Using a Drill for Deer Food Plots


Question: When using a drill to put in whitetail food plots, how do you plant the seeds in rows without going over the same row that you’ve already planted? I’ve broadcasted seeds before and I would broadcast the appropriate pounds of seeds per acre until the plot is finished, but how do you do that with a drill?

Answer: It will take a little practice using a seed drill, but using your drill will become very easy over time and really help you get your food plots in fast. First, planting seeds in tilled ground is much easier to see where you’ve been and probably the best way to learn. Start out by making the first pass along the outside edge of the plot. Once you’re at the end, just raise the drill, make a sharp turn and start planting again right beside the first pass, you should be able to see where the last “row” is. Just get it as close as you can without overlapping or leaving a gap of unseeded ground.

Most drills are equipped with a seed metering system, which controls the seed drop rate. Once you determine what seed you’re planting and how many pounds per acre, look either on the drill or owners manual for which gear or gearbox setting needed to achieve that rate with that particular seed. Using a drill involves a learning curve, but it’s well worth the trouble for a good food plot that provides valuable supplemental food. Good luck with your plot and your deer management.

Leave a Reply

Your email address will not be published. Required fields are marked *